Posts tagged "aerial photo"

AWuAV 3015E the Revolutionary Open Source drone The Pixracer is the first autopilot of the new FMUv4 Pixhawk generation. It has Wifi built-in, comes with upgraded sensors and more flash. The final revision of this new design will likely consolidate on a single set of sensors (either ICM or MPU, both from Invensense). Integrated Wifi …
Continue reading Pixracer Autopilot

Compagnon Computer AWuAV 3015E the Revolutionary Open Source drone Companion Computer Companion Computer can be used to interface and communicate with ArduPilot on a flight controller using the MAVLink protocol. By doing this your companion computer gets all the MAVLink data produced by the autopilot (including GPS data) and can use it to make intelligent …
Continue reading Compagnon Computer

AWuAV 3015E the Revolutionary Open Source drone   AWuAV “Annular Wing Unmanned Air Vehicle” The vehicle has only 2 parts the ring wing and the motor-propeller no other moving parts for a gain in weight. AWuAV is controlled only by a Thrust Vectoring Flight Control (TVFC) WHY A ANNULAR WING A shrouded ducted annular wing …
Continue reading How it Works

Communique After the introduction of the revolutionary AWuAV 3015E drone intended for the general public and small commercial applications. AWuAV planned for July 2018 the marketing of: AWUAV 6540G Diameter 65 cm Hight 40cm Wl less weight 9.5kg Propeller 25×13” Motor Twin Gas Engine 19.5hp Mtow Maximum takeoff weight 30.5kg Max Payload and Fuel 21kg …
Continue reading Investors

AWuAV 3015E the Revolutionary Open Source drone This is QGroundControl QGroundControl provides full flight control and vehicle setup for PX4 or ArduPilot powered vehicles. It provides easy and straightforward usage for beginners, while still delivering high end feature support for experienced users. Key Features: Full setup/configuration of ArduPilot and PX4 Pro powered vehicles. Flight support …
Continue reading QGroundControl for Pixracer

PAYLOAD (2kg max) Space available in the electronic box (for your electronic). The payload can be placed at the top (max 7cm diameterx10cm high) and or under the drone. Max size 25cm long 25cm wide 20cm high (under the drone).   The Payload Landing Gear fixations are in place to fix your payload.   ACCESSOIRIES …
Continue reading Payload